Normally do not use data at wind directions of +/- 45 degrees from 180 (in sonic coordinates). For RIM, I used +/- 120 degrees. Also at RIM, I find more believable lean angles by setting w.off = 0. Used the latter results in the RIM cal_files.
Can recalculate these at end of project.
sonic | lean (deg) | leanaz (deg) | w offset (cm/s) |
---|---|---|---|
3m.near | 0.6 | 1.5 | -1 |
10m.near | 1.0 | 11.5 | -2 |
15m.near | 0.6 | 47.9 | 0 |
20m.near | 0.7 | 32.3 | -1 |
25m.near | 1.1 | 77.9 | -1 |
30m.near | 0.7 | 32.3 | -1 |
35m.near | 0.9 | 114.5 | -2 |
40m.near | 0.8 | 89.3 | 0 |
45m.near | 1.2 | 47.8 | -1 |
50m.near | 1.0 | 37.4 | 0 |
5m.rim | 1.5 | -140.5 | -7 |
| 1.4 | -97.7 | 0 |
10m.rim | 3.0 | 153.3 | -14 |
| 2.2 | -122.2 | 0 |
15m.rim | 2.8 | -163.9 | -21 |
| 1.5 | -116.9 | 0 |
20m.rim | 2.9 | -168 | -24 |
| 1.2 | -127.4 | 0 |
25m.rim | 3.3 | 178.6 | -29 |
| 1.0 | -164.7 | 0 |
30m.rim | 3.5 | -179.1 | -29 |
| 1.3 | -161.8 | 0 |
35m.rim | 3.0 | -177.5 | -32 |
| 0.8 | -135.5 | 0 |
40m.rim | 3.6 | -156.5 | -31 |
| 2.1 | -115.3 | 0 |
3m.far | 1.0 | -31.6 | -1 |
3m.flr | 0.5 | 167.6 | -3 |
3m.ssw2 | 10.2 | -59.1 | 2 |
3m.ssw4 | 30.6 | -39.4 | -4 |