Versions Compared


  • This line was added.
  • This line was removed.
  • Formatting was changed.
Comment: Migrated to Confluence 4.0


~12:00: Found that the interface board to 11b had pulled out of pressure2's
motherboard. Reset.


  • Cycled power twice to upwind to get Pocketec running. Replaced the
    Pocketec in the process.
  • Swapped 4G sticks in pressure1 and pressure2
  • Have now downloaded all of these drives/sticks still need merge

~13:00 changed config. Restarted statsproc. covar_redo to go back to beginning
of this config. Config has new horiz array heights and new names for
some pressure sensors. Still need new heights for profile...

~13:30 We're off to Moro Bay for some R&R&R...

Wiki MarkupI sometimes get the following error when trying "aup", but a second "aup" always works:
Starting adam code.../usr/local/isff/scripts/adam/start_adam: line 30: 11238 Illegal instruction dsm '$ISFF/projects/$PROJECT/ISFF/config/'$CONFIG_XM
. \
[Gordon says that this is an artifact of moving code from Viper RAM to SD card. If second
"aup" works, live with it.\]

8/12 (twh: actually 8/11):

0945 - unpinched tubing to P.bedard
0950 - turned "profile" adam off to swap serial card
1005 - turned "profile" back on - don't have 8M card (rather than 8P)
1020-1030 - moved bedard port from on stake near ground to 13b boom (back a bit
from sonic)
1106 - added "adnaup" crontab on profile to restart every hour at 15 min after the hour.

  • measured all heights on profile:

1150-1210: replaced CSAT 720 with 733 at profile.8m (since high? speeds). (733 was the original "low" sonic at 8m when I arrived here, I think...)