You are viewing an old version of this page. View the current version.

Compare with Current View Page History

« Previous Version 2 Next »

EantG went down at 05:21:59 UTC. Log file on the ap24eth again mentions "extensive data loss".  EantH  and EantI (sodar) stayed up.

I'm not sure that changing the frequency, as was done earlier, changes anything. After changing the frequency, the Etherants still indicated that they are using channel #1.

Will now try setting the  disconnect-timeout parameter to 15 seconds (the maximum allowed value). The default is 3 seconds.  Will also increase the on-fail-retry-time to 1/2 second

interface wireless set 1 disconnect-timeouot=15s
interface wireless set 1 on-fail-retry-time=500ms

Here are the current wireless interface settings:

 1  R name="wlan2-Ext-Ant" mtu=1500 mac-address=00:15:6D:10:3C:BC arp=enabled
      disable-running-check=no interface-type=Atheros AR5213 radio-name="AP24-ExtAnt"
      mode=ap-bridge ssid="ISFF14" area="" frequency-mode=manual-txpower country=united states
      antenna-gain=0 frequency=2462 band=2.4ghz-b/g scan-list=default rate-set=default
      supported-rates-b=1Mbps,2Mbps,5.5Mbps,11Mbps
      supported-rates-a/g=6Mbps,9Mbps,12Mbps,18Mbps,24Mbps,36Mbps,48Mbps,54Mbps
      basic-rates-b=1Mbps basic-rates-a/g=6Mbps max-station-count=50 ack-timeout=dynamic
      tx-power=25 tx-power-mode=all-rates-fixed noise-floor-threshold=default
      periodic-calibration=default periodic-calibration-interval=60 burst-time=disabled
      dfs-mode=radar-detect antenna-mode=ant-a wds-mode=disabled wds-default-bridge=none
      wds-default-cost=100 wds-cost-range=50-150 wds-ignore-ssid=no
      update-stats-interval=disabled default-authentication=no default-forwarding=no
      default-ap-tx-limit=0 default-client-tx-limit=0 proprietary-extensions=post-2.9.25
      hide-ssid=yes security-profile=isffwep disconnect-timeout=3s on-fail-retry-time=100ms
      preamble-mode=both compression=no allow-sharedkey=no
  • No labels