Gordon, Nov 9
Chris hooked up the EC150 via USB to the flux laptop. It comes up as a typical serial device /dev/ttyUSB0, so I talked to it with minicom, 115200 baud. It is currently set for 10Hz reporting, so I didn't change anything.
Code Block |
---|
EC100>H Terminal Mode Commands: D: Parameter Dump E: Load CalFile K: Dump cal file N: Bandwidth, ECMon Rate, and Unprompted Rate configure O: Pressure, Temperature sensor menu S: Set Parameters X: Save Setup to FLASH Z: Change user calibration coefficients (manually or span/zero) EC100>N Bandwidth = 12.5Hz, ECMon Rate = 10Hz, Unprompted Rate = 10Hz 1) Modify Bandwidth. 2) Modify ECMon Rate. 3) Modify Unprompted Rate. Enter Selection: EC100>D Copyright (C) Campbell Scientific Inc. OS Version: EC100.03, OS Date: 2012-09-19 12:07:38 Board Srl#: 1313-5.1 Gas Id: , Gas Cal Date: Sonic Id: , Sonic Cal Date: SDM Address: 1, Bandwidth: 12.5Hz Lifetime timer: 0.000000 Hours EC100> |