You are viewing an old version of this page. View the current version.

Compare with Current View Page History

« Previous Version 3 Next »

The 2m licor connected to /dev/ttyS2 was removed today.

The licors at 16 meters and 43 were reconnected to ports
/dev/ttyS11 and /dev/ttyS17, but we're not sure at this point
which was connected to which port. Perhaps we can query the
serial numbers to determine which is where.

port

height

ttyS2

removed

ttyS7

7m

ttyS11

either 16 or 43 meters, need to verify

ttyS14

30m

ttyS17

either 16 or 43 meters

First test: 4 licors running at 10Hz, 19200 baud

(Outputs (BW 10) (RS232 (Freq 10.0)  (Baud 19200) (EOL "0A") (CO2Raw TRUE) (CO2D TRUE) (H2ORaw TRUE) (H2OD TRUE)
  (Temp  TRUE) (Pres TRUE) (DiagVal TRUE)))

This resulted in around 1200 spurious interrupts being reported in /var/log/isfs/kernel

Second test: 4 licors running at 5 Hz, 19200 baud

(Outputs (BW 5) (RS232 (Freq 5.0)  (Baud 19200) (EOL "0A") (CO2Raw TRUE) (CO2D TRUE) (H2ORaw TRUE) (H2OD TRUE) 
  (Temp  TRUE) (Pres TRUE) (DiagVal TRUE)))

This resulted in around 300 spurious interrupts being reported in /var/log/isfs/kernel

Second test: 4 licors running at 5 Hz, 9600 baud

(Outputs (BW 5) (RS232 (Freq 5.0)  (Baud 9600) (EOL "0A") (CO2Raw TRUE) (CO2D TRUE) (H2ORaw TRUE) (H2OD TRUE) 
  (Temp  TRUE) (Pres TRUE) (DiagVal TRUE)))

This resulted in usually less than 50 spurious interrupts being reported in /var/log/isfs/kernel. The kernel won't report more than
50, so this means there were very few reports of spurious interrupts.

Left it running at this setting.

Current values from /proc/tty/driver/serial:

2: uart:XScale mmio:0x40700000 irq:13 tx:543 rx:1136277465 fe:1947 RTS|DTR

7: uart:ST16654 port:F1000110 irq:104 tx:1111 rx:1153977325 fe:41917 RTS|DTR

11: uart:ST16654 port:F1000130 irq:104 tx:1585 rx:3762900 fe:21542 RTS|DTR

14: uart:ST16654 port:F1000148 irq:104 tx:1549 rx:575482383 fe:3996 RTS|DTR

17: uart:ST16654 port:F1000160 irq:104 tx:1079 rx:2059346 fe:2312 RTS|DTR
  • No labels